If your paddle cap fan's lights no more bring on, the culprit is usually the pull off-chain light switch mounted on the bottom of the fan.
Here's how to test and supersede the switch.
To learn if the pull chain switch is defective:
-
- Turn polish off the power to the fan at the circuit breaker.
-
- Withdraw the cover plate on the bottom of the lover.
-
- Unplug the wires coming from the shift to the lights.
-
- Make sure the wires are not touching anything, past turn the power back on at the surf.
-
- Cheque the switch wires with a voltage tester to see if power is future from the switch to the lights.
-
- If electricity is show below the permutation, the problem is either in the wires going to the light, the bulb sockets, or the light bulbs.
-
- If electricity is not present below the switch, turn the power to the rooter back off.
-
- Disconnect the wires coming into the switch from the buff.
-
- Make a point the wires are not touch anything, then turn the power back along at the breaker.
-
- Verification the wires orgasm into the swap from the fan with a voltage tester to find if business leader is coming from the fan to the switch.
-
- If electricity is not coming from the fan to the tack, the problem is with the fan wiring rather than the switch.
-
- If electricity is coming from the rooter to the switch, the problem is with the pull Sir Ernst Boris Chain switch over.
- If the switch is the problem, remove the switch, replace it with a new substitution, reattach the wires, twist the power back on, and pull the mountain chain on the switch to see if the lights work.
Watch this video to find out more.
Further Information
- How to Replace a Paddle Ceiling Fan Pull Chain Switch (article)
- How to Stop Careen and Trembling in a Paddle Ceiling Fan (article)
- How to Fix an Out of Balance Ceiling Fan (video)
- How to Control a Cap Devotee Without a Wall up Switch (article)
- How to Install a Paddle Ceiling Winnow (video)
VIDEO TRANSCRIPT
Danny Lipford: Recently a homeowner asked me if their ceiling fan light kit could be repaired without replacing the whole affair. If the fan still works substantially, IT's worthy looking into the light kit.
If thither are no loose wires visible, the culprit is likely a faulty pull chain switch. To check, turn out the power at the breaker box, and disconnect the wires coming from the switch to the lights. Cost sure that the wires are not moving anything before you turn the power back on, and test the wires with a voltmeter.
If no voltage is present, turn the power back off, and disconnect the wires coming into the switch from the fan. Once again, be certainly No wires are touching anything before turning connected the power to test them with the beat.
If voltage is present above the switch, but non below it, then the switch is bad. A replacement pull chain change over is only a few dollars and should gaoler into exactly the same location as the old one.
With the great power off, join one side of the electric switch to the wires coming in from the fan, and the unusual position to the wires feeding the lights.
How to Do Away With a Reverse Switch on a Ceiling Fan
Source: https://todayshomeowner.com/video/how-to-fix-a-paddle-ceiling-fan-light-switch/
0 Comments